I’m looking for a technical position where my skill are valued. Within the amount of knowledge I have learn from university, experiences. Addition to a creative, youth, enthusiastic, passion as well as sense of responsibility in my work. Moreover, with full of energy I wanna face to new challenges to gain knowledge as well as a life.
I hope, I can contribute my small portion into the development of organization and company.
GPA: 7.23 / 10.
– Following status all of the equipment in the factory.
– Make a plan to preventive maintenance works.
– Ensure all machines are always in the best status, smooth operation.
– Fixing the errors have occurs as soon as possible.
– Finding a root cause base on the 4M, 5WH.
– Solving strictly a problem and improvement the machine to works more effectively.
Recognition and Gains:
– Programming PLC, servo, inverter Mitsubishi, HMI
– Coordinating with other departments for reduce tact time.
– Linking PLC Mitsubishi through CC-Link instead communication by relay at Metal Line
– Install new inverter Mitsubishi and control multiple speed to control hydraulic pumps at Metal Line.
– The air pressure will be control butterfly valve but broken many times. That valve had replaced by servo Mitsubishi at Liner Forming.
– Programming parallel mode in a Test cell process.
– Addition more code table in HMI Pro-face.
– Design graphic, alarm, sequence step describe operation machine.
– Operation manual mode robot Kawasaki, Kuka.
– Learn a lot of Factory Automation equipment fields.
– Coording with other department to improve process.
– Transfer machine and install station from factory 1 to factory 3.
Recognition and Gains:
– Improvement Grinder machine from manual to automatic by PLC Siemens
– Improvement control and check Rail by PLC Siemens and C#.
– Build soft check Packing line and Hrad machine component by C#.
– Build soft Insert data check and print KU product by C#.
– Learn new technologies 2C, 1C product from factory at Thai Land.
– Install and calibration process check alignment and loss, soldering, polishing station.
– Management a part list and for each station.
– Make a document for training technicians.
– Build a program to OP control that station by software.
Recognition and Gains:
– Programming C# for Measurement and Judgment leak Heli test and Soldering, checking loss 2C.
– Make new mixing clue by Arduino.
– Modify Ring and Tunes program for Medical line.